KKR Solid Surface - Custom solid surface manufacturer & acrylic solid surface sheet factory over 19 years

Bathroom accessories installation process-bathroom accessories, installation process

by:KKR Solid Surface     2022-05-09

Bathroom accessories installation process Bathroom decoration mainly involves two aspects of wall tiles and sanitary ware. The construction process is roughly as follows: inlaid wall tiles, suspended ceilings, floor tiles, toilets, washbasins, bathtubs, connections, water supply and drainage pipes, lamps, sockets , mirror installation towel bars and other hardware accessories. The construction process of the washbasin Insert the expansion bolts and twist them firmly. After hanging the basin pipe frame, put the washbasin on the frame to level it. The construction process of the bathtub First install the bathtub and then install the water, seal it tightly with putty, and then install the water, and then try to level it. The construction process of the shower is to level the cold and hot water pipes with test tubes, install the measured short joint size on the pipe mouth, apply lead oil to the copper water inlet of the shower, wrap and tighten the nut, and fix it on the wall. Install the upper copper pipe to the tee, and then fix it to the wall with wood screws. The construction process of the bidet is to first level the mixing switch, the door cover and nut of the hot and cold water door, then install the water door and the nozzle rotary core door, and then tighten the outlet nut of the hot and cold water door and the nut on the mixing switch respectively, and then install the three Install the magnetic basin after the water gate cover, install the water outlet when installing the nozzle, and then install the hand lever, and then adjust the positioning. In the construction process of the toilet, first check the water outlet pipe on the ground, draw a mark after aligning the nozzle, punch holes, then apply putty to cover the rubber pad and tighten the nut, and make marks on the two side holes on the back of the water tank. Insert the bolts and twist them firmly. After tightening the nuts on the back of the water tank, install the water elbow of the back water tank, and install the eight-character door. After bending the fork of the mother lamp, insert it into the float door and the eight-character door.

Custom message
Chat Online 编辑模式下无法使用
Leave Your Message inputting...